Your gas Furnace in Toledo OH is the unit that heats your indoor air. When this device is defective, it can affect the health of household occupants. Before getting a technician to look at it, there are some actions to perform. This can save on expensive repair costs and get your furnace working again quickly. Use the following guidelines to do successfully complete these tasks.
When your gas Furnace in Toledo does not produce heat, check the circuit breaker or fuse at the main entrance panel. Ensure that it’s in the “on” mode. You may have to replace a blown fuse or reset a tripped circuit breaker. Next, look at your thermostat. It should be in the “heat” mode. Raise the temperature indicator above the temperature of the room. The thermostat should also be in the “on” position. It may take a few moments for the furnace to turn due to the condenser coil having to heat up. Check the control valve for the gas. It should be turned halfway to let in the proper amount of gas. When it’s shut off, refer to the instruction manual for the proper amount of gas to let into your furnace.
If the above actions don’t result in your furnace heating correctly, check the condition of the filter. A disposable filter should be replaced and a metal one should be cleaned. You can purchase a new filter by looking at the numbers on the side of the old filter. There may be problems with airflow. Inspect the duct-work for obstructions. The air intake should be free of hindrances as well. The pilot light may need to be relit. Again, read the instruction manual to do this the right way. The vent connector should be securely attached to the furnace so flue gas can escape the furnace.
When your furnace is not doing the job it was manufactured to do, you may have to call a professional like the ones at Atlas Heating Co. This will allow you to restore functionality to your furnace and prolong its useful life. Residential and commercial furnace services are offered by this company.
