If you are taking on a task that includes Foundation Repair, at some point you will need to reinforce the concrete. There are many contractors specializing in Reinforcer Installations in Washington, PA that can assist you. Installation that involves reinforcing concrete is fairly simple if you follow the guidelines. Reinforcing the concrete helps to prevent cracking and dislocation. If you are a beginner or private citizen planning to install concrete for your driveway or some other part of your house and you want it to last a long time, there are several things that need to be done.
To keep things lined correctly, be sure to mark the boundaries of the concrete slab with chalk. To keep the line straight, have someone stand at both ends of the line, each pulling a string and releasing it so it will leave a line of dust in the ground. Then place wooden stakes approximately three inches from the corner so there is enough space for the boards and stakes. To establish the boundaries in the area, tie the string to the stakes.
The next step is to dig up the soil that is located within the boundaries or strings. Remove the soil at least five inches deep. With the back of the shovel, tap down the ground so it will create a smooth surface. To prevent unwanted vegetation, spray the area with a good weed killer. One thing that can take away from newly laid concrete is to have weeds sticking out from it, making it look bad.
The next step is to insert wooden stakes at least three feet into the area with a hammer. You only want an inch of the stake above ground. In order to secure the boards to the wooden stakes, use double-headed nails. This will allow the board to be even with the wooden stakes. The board should provide a solid foundation of the area. Spread about two inches of gravel making sure it is smooth. You can do this with the back of the shovel or some other piece of leveled equipment. Make sure the area is smooth to allow proper drainage.
Next, place stones or rocks around the area to hold the material in place. Place wires to reinforce the area. Finally, pour the concrete on the boards. You don’t need to remove the rocks. Smooth the area. For more information about Reinforcer Installations in Washington, PA contact a foundation repair company.
